PDA

View Full Version : Evolv x and cooler master 360r



Denny
04-29-2019, 03:28 PM
I have the Phanteks Evolv X and the Cooler Master Masterliquid ML360R RGB cooler.
The cooler instructions say if I plug in the case reset cable into the cooler controller, the case can control the cooler LEDs.
This case has a POWER cable BUT no reset cable. Does anyone know a way to have the case control the cooler LEDs.

Denny
04-30-2019, 09:33 AM
OK I found the reset cable and installed it BUT there is a second shorter 2 wire cable. The video I watched umpteen times used the second cable but is not clear in showing where it goes on the motherboard. I have the ASUS Maximus XI Extreme motherboard. The 2 wire cable would plug into the controller beside the reset cable BUT where does it plug into the motherboard? It must be near the reset plug.