Search:

Type: Posts; User: zlegendof

Search: Search took 0.05 seconds.

  1. Replies
    28
    Views
    30,000

    Unfortunately, there is no way to mount a 280mm...

    Unfortunately, there is no way to mount a 280mm rad in the front of the Evolv ATX without removing the HDD cage below due to the hole spacing. A 240mm should have no problem however.

    Why not mount...
  2. Replies
    2
    Views
    9,444

    Both of those should work since they just fit...

    Both of those should work since they just fit into the existing 7 or 8 slots on any ATX case. The only mod you would need to do is to cut off the horizontal pieces that are in between each slot on...
  3. Replies
    1
    Views
    7,007

    I too have modded the top of my Evolv ATX TG...

    I too have modded the top of my Evolv ATX TG similar to that. Albeit the metal mesh on mine has bigger holes causing me to occasionally clean out the inside of my case as dust falls in. No big deal...
  4. Replies
    40
    Views
    30,170

    Thank you very much for letting me know :D I...

    Thank you very much for letting me know :D

    I should probably start following them on Twitter...haha
  5. 713714 3x 140mm fans fitted snugly in the...

    713714

    3x 140mm fans fitted snugly in the front. I was able to do this by removing the bottom fan mounting piece. Not the prettiest mod, but hey it works.
  6. Replies
    40
    Views
    30,170

    Enthoo Evolv mATX TG

    I may by the only one excited for this case. It was shown at the beginning of this HardwareCanucks video


    https://www.youtube.com/watch?v=cCulP4bSTlw&

    Does anyone know when this will be...
  7. 3x 120mm fans can definitely fit in the front of...

    3x 120mm fans can definitely fit in the front of the Evolv ATX TG. What I did when I ran this setup was only screw in the top two screws on the bottom fan. I did this to avoid the pain of removing...
Results 1 to 7 of 7