Results 1 to 4 of 4

Thread: Evolv mATX + Kraken X62

  1. #1

    Evolv mATX + Kraken X62

    In users manual it says that 280mm radiator does not fit on top of the case.

    http://www.phanteks.com/assets/manua...TG_Western.pdf

    page 20

    But here on web site is says that it fit!

    http://www.phanteks.com/Enthoo-Evolv...eredGlass.html

    So i'm asking, 280m radiator fits or not?

  2. #2
    Super Moderator
    Join Date
    May 2013
    Location
    United Kingdom
    Posts
    851
    Quote Originally Posted by Sigma957 View Post
    In users manual it says that 280mm radiator does not fit on top of the case.

    http://www.phanteks.com/assets/manua...TG_Western.pdf

    page 20

    But here on web site is says that it fit!

    http://www.phanteks.com/Enthoo-Evolv...eredGlass.html

    So i'm asking, 280m radiator fits or not?
    While I have not tried to fit a 280mm radiator, it does look like they might fit. Best bet would be to contact Phanteks support and ask them. If that doesn't work in a week or so, let me know and I'll try fitting my be quiet! Silent Loop 280mm into my Evolv mATX
    =i7 980X @ 3.55GHz =PH-TC14PE w/2x TY-147A fans =Crucial Ballistix 3x4GB =GA-X58A-UD5 =ENGTX580 DirectCU II =e quiet! Straight Power E10 500W =Enthoo Evolv w/2x PH-F140XP case intake fans;

  3. #3
    Quote Originally Posted by doyll View Post
    While I have not tried to fit a 280mm radiator, it does look like they might fit. Best bet would be to contact Phanteks support and ask them. If that doesn't work in a week or so, let me know and I'll try fitting my be quiet! Silent Loop 280mm into my Evolv mATX
    Phanteks support team says it fit. I think they just need to update online manual.

  4. #4
    Hello. I just (20 minutes ago) finished a build with both of these and it does fit in the top just fine. It actually fits in the front too, with that removable metal tray at the bottom needing to be removed (but could be slid back in after), but unfortunately not with the GPU I picked (EVGA 1080 Ti FTW3)... about 5mm or so too tight. I was pretty annoyed, but then realized putting the rad at the top wasn't that big of a deal either, aside from having to remove most parts and re-build it all. I have yet to even boot it, so fingers crossed, but remembered seeing this post on here and figured I'd post a confirmation.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •