PDA

View Full Version : Replacement body panels (ENTHOO Evolv ATX Case)



nyihtway
11-17-2017, 12:43 AM
Hi,
Some body panels of my Enthoo Evolv ATX tempered glass case has been damaged during transportation and need to be replaced. I've sent inquiry email to support@phanteks.com but till not I didn't receive any responses.

I need the following body panels.

1. Left tempered-glass panel
2. Right tempered-glass panel
3. Top body panel
4. Front air filter
5. Front body panel
6. Bottom air filter
7. Bottom foot pieces (front and back)

The shipment address is to Singapore. Please let me know who to contact and how to get those replacement panels.

doyll
11-18-2017, 07:16 AM
Sounds like you might be better off just buying a new case then paying what all these parts will cost.

Is this a new case you just bought? If so I would return it for a replacement.

nyihtway
11-19-2017, 06:32 PM
Sounds like you might be better off just buying a new case then paying what all these parts will cost.

Is this a new case you just bought? If so I would return it for a replacement.
It is a new case but the damage is happened after i received it. So i was not able to return it to the retailer.
I'll wait and see what Phanteks reply officially. If the cost for panels are too much, I'll salvage what i can from the current case and buy a new one. (3x140mm fans, fan controller, RGB controller, HDD mounts are still in good condition.

doyll
11-26-2017, 04:39 AM
May I ask what happened to it?

FYI, Evolv ATX and Enthoo Pro M use same basic case frame with different panels, etc. on it. ;)