PDA

View Full Version : Enthoo Evolv ITX tempered fan screw



antonis990
07-12-2018, 05:52 AM
Hi there,

Recently i purchased the evolv itx case which came with one 140mm fan pre-installed on the back.
I wanted to add another one on the front, so i purchased an Arctic F14 (140mm) fan.
But the fan does not sit on the rails so i can use the typical fan screws. It sits on the chassis holes.
I allready tried M3 which are a little smaller and they dont screw and M4 which are a bit larger and they dont fit in the holes.
I accidentaly found two screws which did the job, but i dont have the others and i dont know what to get (are there M3.5?).
Thanks!

845
846

doyll
07-16-2018, 06:03 AM
I don't know what screws you have, but if you took one to hardware store they can probably match it to something they have in stock.

antonis990
07-23-2018, 05:05 AM
ok thnx!!